CWNP CWDP-305 Practice Exams
Last updated on Mar 31,2025- Exam Code: CWDP-305
- Exam Name: Certified Wireless Design Professional
- Certification Provider: CWNP
- Latest update: Mar 31,2025
In a multiple channel architecture (MCA) network supporting 802.1X authentication, what aspect of WLAN design affects client roaming efficiency and effectiveness?
- A . PHY standard used by the AP
- B . Key caching protocols
- C . Cipher suite
- D . PHY standard used by client
In a multiple channel architecture (MCA) network supporting 802.1X authentication, what aspect of WLAN design affects client roaming efficiency and effectiveness?
- A . PHY standard used by the AP
- B . Key caching protocols
- C . Cipher suite
- D . PHY standard used by client
Modulation can be defined as:
- A . The process of incorporating a chipping code to build resilience
- B . The process of encoding data symbols using a carrier frequency
- C . The process of modifying a carrier signal to represent data
- D . The process of representing data using RF coding
What two 802.11 amendments deal with regulatory and transmission requirements?
- A . 802.11k
- B . 802.11i
- C . 802.11d
- D . 802.11f
- E . 802.11h
11n chip that supports two spatial streams.
What is the maximum MCS rate that could be supported by this AP?
- A . 54 Mbps
- B . 65 Mbps
- C . 108 Mbps
- D . 144 Mbps
What operational plane would a WNMS primarily interact with?
- A . Integration
- B . Management
- C . Control
- D . Data
- E . Distribution
To increase capacity in a coverage-based wireless network, which of the following techniques are typically recommended? (Choose all that apply.)
- A . Maximize airtime usage by disabling lower data rates.
- B . Add additional APs and use directional antennas.
- C . Turn up power on the access points.
- D . Lower power on the access points and, after careful planning, add more AP
Using a SCA means that all APs will be using the same channel in a given layer.
How is the AP with which the client associates determined?
- A . All APs share a virtual IP address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.
- B . All APs share a virtual Multicast Address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.
- C . All APs share a virtual BSSID. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.
- D . The client selects the AP based on a known set of MAC to BSSID mappings stored in the clients authorized SSID listing.
An amplifier has a 1 dB compression point of 32 dBm and a gain of 20 dB.
Which is the highest average input power shown here that would be safe to operate a 24 Mbps 802.11g signal so that spectral regrowth is not a problem?
- A . 5 dBm
- B . 0 dBm
- C . 5 dBm
- D . 10 dBm
Given:
In your regulatory domain, a Tx Power Level of "1" is equivalent to 17 dBm.
For every integer increment (e.g. from 1 to 2) to the Tx Power Level, the APs transmit power is halved.
In units of mW, what is the actual transmit power for an AP configured at a Tx Power Level of "4"?
- A . 6.25 mW
- B . 50 mW
- C . 12.5 mW
- D . 8 mW